Elecbee 12V-36V 500W PWM Brushless Motor Controller with Hall/Non-Hall Support for Speed Regulation Balanced Car Control

VCC(positive power supply)

GND(negative one)

MC(motor phases W)

MB(motor phases V)

MA(motor phase U)

GND control terminal ground

VR  the governor end 0-5V(corresponding to 10% of motor speed -100%)

ZF  reversing control(connected to 5V or ground can charge the motor rotation direction)

M  tachometer pulse output(depending on the number of motor poles corresponding to the number of pulse per revolution of the output number)

EL  enable control terminal(connected to 5V ot ground running then 5V, grounding the motor stops)

5V  5V control terminal

5V, Hall power positive

Ha, Hall signal

Hb, Hall signal

Hc, Hall Signal

GND, Hall negative

1. The motor speed control wiring methods: available potentiometer system speed can also be connected to the MCU control, when the potentiometer control wiring, the potentiometer middle pin is connected to VR speed port, potentiometer connected to both ends of 5V and GND terminal voltage more high speed faster

2. Motor steering control wiring methods: you can switch control can also be connected to the MCU control, to GND in one direction, then in one direction 5V

3. Pulse speed signal: high and low output . IC can not understand the information with the customer request

Wiring diagram is shown, one corresponding to the HA, HB,HC and on the motor, 5V power supply connected to the motor hal signals positive, GND power supply negative signal to the motor hall

Tips: If you use less than 60W, without additional heat sink , be sure to add more than 60W heatsink fins drive efficiency without lowering the temperature is too high will shine into permanent damage! The size of the heat sink may be a bad environment based work(recommended cooling surface area greater than 200 square centimeters)!When installing the heat sink ,must pay attention to the back of the module 6 MOS pipe insulation, no insulation, it will be adhered to drive plate permanently damaged! Proposes to add insulation films, both sides of the insulating sheet plus thermal grease!

1 x Controller