Elecbee SpeedyBee F7 V3 Flight Controller

Features

500MB Onboard Blackbox Flash memory

8 Motor output perfect for X8 Cinelifters

30.5 x 30.5mm Mounting Pattern

FC LiPo Monitoring System

Built-in Barometer

4 LED Plugs

F722 FC

Buzzer

 

Specifications

Power Output:

1) 10 groups of 5V output, three +5V pads and 1 BZ+ pad (used for Buzzer) on the front side, and 6 +5V output included in the connectors on the bottom side. The total current load is 2A.

2) 2 groups of 9V output, one +9V pad on the front side and the other included in a connector on the bottom side. The total current load is 4A.

3) Supported. Designed for receiver and GPS module even when the FC is powered through the USB port. Up to 1A current load Supported. Designed for 3.3V-input receivers. Up to 500mA current load.

WiFi Support, used for data transfer, e.g firmware flashing, and Blackbox analysis.

I2C: Supported. SDA & SCL pads on the front side. Used for magnetometer, sonar, etc.

Support Flight Controller Firmware: BetaFlight(Default), EMUFlight, INAV

ESC signal M1 - M4 on the bottom side and M5-M8 on the front side.

LED: Used for WS2812 LED controlled by Betaflight firmware.

UART: 5 sets (UART1, UART2, UART3, UART4, UART6)

DJI Air Unit plug: A full DJI Air Unit JST slot onboard

BLE Support, used for Flight Controller configuration

Buzzer: BZ+ and BZ- pad used for 5V Buzzer

Mounting: 30.5x30.5mm, 4mm hole size

Dimensions: 41(L) x 38(W) x 8.1(H)mm

OSD: BetaFlight OSD w/ AT7456E chip

BlackBox: 500MB onboard data flash

BetaFlight Camera Control Pad: Yes

ESC Telemetry: UART UART4 RX

Power input: 3S - 6S Lipo

Target: SPEEDYBEEF7V3

SmartPort: Supported

Baro: BMP280 (I2C)

MCU: STM32F722

Boot button: Yes

RSSI input: Yes

IMU: BMI270

USB: Type-C

Weight: 9G

 

 

 

package inclusion

1x SpeedyBee F7 V3 Flight Controller

1 4-Pin SH1.0 to SH1.0 Analog VTX Cable 60mm - Yellow and Blue

1x 6-Pin SH1.0 GPS module Cable without connector - 100mm

1 4-Pin SH1.0 to 3+ 2-Pin JST1.25 FPV Camera Cable - 30mm

1 4-Pin SH1.0 to 3+ 2-Pin JST1.25 FPV Camera Cable - 60mm

1 4-Pin SH1.0 to 4-Pin JST1.25 FPV Camera Cable - 60mm

1x 6-Pin SH1.0 GPS module Cable with connector

1 4-Pin SH1.0 Radio Receiver Cable - 100mm

1x SH 1.0mm 8-Pin Cable -30mm

5x M3 8mm Silicone Grommets

1x DJI 6-Pin Cable - 80mm