Elecbee 1x6P 2x3P Bootloader Flash Tool Board Micro-USB IDE

1#: 1x6P

2#: 2x3P

What is it?

It is a bootloader flash tool for Ardui o products. If you do not understand what is bootloader I suggest you have a look this:

• Bootloader Development
• Ardui o as ISP and Ardui o Bootloaders

Why did you make it?

Now I have some Arudino products like Wifi Duck... Bootloader is a problem during Ardui o develop process. I want to share my exprience for those Ardui o developers. Now I only use Ardui o Leonardo as my target but theoretically other target is also OK.

What makes it special?

It is pre-flashed with Ardui o ISP software

• Connect Flash Tool and computer via a Micro-USB cable.
• Connect Flash Tool to the target board.
• Indicate LED will turn off for about 10 seconds.
• Wait until LED turn up .
• Open Ardui o IDE and select the item in the Tools->Board menu that corresponds to the board on which you want to burn the bootloader (Ardui o Uno,Nano,Leonardo...).
• Select Port COMXX(Ardui o Leonardo) .
• Select the Ardui o as ISP(Atmega32u4) in the Tools>Programmer menu.
• Use the Burn Bootloader command.
• You will see Indicate LED is twinkling when burning process start.
• Twinkling LED will be off and software says "Finish" at the same time when buring process finish.

Package Included:

1 x 1x6P/2x3P DSTIKE Bootloader Flash Tool