Elecbee PoE Base LAN Module W5500 with POE Ethernet Controller RS485/RS232 Data Forwarding ESP-IDF Support

 

Base PoE is an M5 Base that implements a W5500 Ethernet controller chip with PoE module, which provides Hardwired TCP/IP embedded Ethernet control to facilitate easier internet connection to embedded systems. W5500 integrates TCP/IP protocol stack, 10/100M Ethernet data link layer (MAC) and physical layer (PHY).This base supports RS485 / RS232 communication and can be used as an Ethernet to serial port server. It is specifically designed for industrial applications. PoE (Power over Ethernet) technology is supported. Through the built-in PoE module, power can be directly supplied to the base through PoE hub / switch without a separate power supply. It comes with a couple of HT3.96 connectors, metal rail and magnet discs for easy installation. The 6 pins of the HT3.96 connector are spare, you can wire them up with an RS485 or RS232 adapter board as you like.

 

 Package Included:

 

- 1x PoE Base

- 1x TTL-to-RS485 adapter board

- 1x TTL-to-RS232 adapter board

- 1x pin header 20pin

- 1x metal rails and magnet discs

- 3x HT3.96 terminal

* 2x 3pin

* 1x 4pin

- 10x cold crimp terminal（red Copper Lugs）

- 3x Allen wrench

* 1x 1.5mm

* 1x 2mm

* 1x 2.5mm

- 2x hexagon socket head cap screws M3x28

- 4x hexagon socket tapping screw KA2x4

- 1x countersunk head screw M3x8

 

 

 

 

 

M5Stack	GPIO13	GPIO18	GPIO19	GPIO23	GPIO26	GPIO34	GPIO5	GPIO15
W5500 PoE	RST	CLK	MISO	MOSI	CS	INT	RX/A	TX/B

 

Right side M-BUS pin definition: 

 

Schematic: 

 

 

 

 

Get Arduin code click here: contact us