Elecbee JDY-10 bluetooth 4.0 Module BLE bluetooth Serial Port Module Compatible With CC2541 Slave

xa0
1: Support Android, IOS mobile phone data penetration
2: Support low power consumption (standby current can reach several uA)
3: Support GPIO and UART peripheral interface
4: Support AT command operation
5: Can be certified by FCC/CE and other standards
xa0
Product application range:
xa0
1: bluetooth LED lighting
2: Motor adjustment and other products
3: Anti-lost alarm and other products
4: Sports Health Care
5: Small appliances
6: Automotive Electronics
xa0
Technical specifications:
xa0

Type		Specifications
Working voltage		1.9 – 3.6V
Operating temperature		-40 - 85°C
Maximum transmit power		+8dbm
Antenna		PCB onboard antenna
Receiving sensitivity		-92dbm
xa0 Average current	Wake mode	90uA
	Suspenxa0mode	14 uA
	Deep Sleepxa0mode	1uA

xa0
Factory default configuration:
xa0
Service UUID: FFE0
Feature UUID: FFE1
Serial port baud rate: 115200bps
xa0
AT instruction set:
xa0
Users can communicate with the bluetooth chip through the serial port. The serial port uses Tx, Rx two signal lines, and the baud rate is supported.
Hold 2400, 4800, 9600, 14400, 19200, 38400, 57600, 115200. The default baud rate of the serial port is 115200bps.
xa0
Instruction set details:
xa0
(Note: You must enter and enter the line when you send the AT command. The AT command can only take effect when the module is not connected. Once the blue is enabled.
When the tooth module is connected to the device, the bluetooth module enters the data transparent transmission mode)
xa0
Detailed instructions:
xa0
(AT commands are case sensitive and end with carriage return, newline characters: rn)
xa0
1. Get the version number:

command	response	parameter
AT+VER	+	Param: version Default: +JDY-10-V1.8

xa0
2.xa0Get the bluetooth MA C address:

command	response	parameter
AT+MA C	+MA C: xa0xa0	Param: MA Cxa0address

xa0
3.xa0Set the bluetooth name:

command	response	parameter
AT+NAME	OK	Param: bluetooth name Default name: JDY-10 Up to 18 bytes

xa0
4.xa0Set / query - transmit power:

command	response	parameter
AT+POWE AT+POWE	OK +POWE:	Param: (0-5) 0: 8db 1: 5db 2: 0db 3:-5db 4: -10db 5: -13db

xa0
5. Set / query - serial port baud rate:

command	response	parameter
AT+BAUD	OK	Param: (0-7) 0: 115200 bps 1: 57600 bps 2: 38400 bps 3: 19200 bps 4: 14400 bps 5: 9600 bps 6: 4800 bps 7: 2400 bps
xa0 AT+BAUD	+BAUD:

xa0
6.xa0Set / query - broadcast interval:

command	response	Parameter
AT+ADVINT	OK	Param:(0-6) 0: 100ms 1: 100ms 2: 250ms 3: 500ms 4: 1600ms 5: 3200ms 6: 4800ms
xa0 AT+ADVINT	+ADVINT: