Elecbee COM.GPS Module NEO-M8N with Antenna ESP32 Development Board Stacking Module Positioning

COM.GPS is a satellite positioning module in the M5Stack stacking module series. It is developed based on the NEO-M8N module and is equipped with an active antenna. The NEO-M8 can spend a small amount of time, conduct high-sensitivity acquisition, and keep the system low power consumption. NEO-M8N integrates the 72-channel u-blox M8 GNSS engine, supports multiple GNSS systems: BeiDou, Galileo, GLONASS, GPS / QZSS, allowing simultaneous reception 3 Data from a GNSS system. Programmable FLASH is integrated inside the module, which can read and write data. The module's high sensitivity, small static drift, low power consumption and compact size are very suitable for applications in vehicles, handheld devices such as PDAs, vehicle monitoring, mobile phones, cameras and other mobile positioning systems. The UART communication protocol is used between the M5Core and the GPS module, and the serial port connection pins can be modified through the dial switch on the back.

If you want to change the serial port baud rate, please click ( u-center-just-for-Windows ).: https://www.u-blox.com/en/product/u-center

Note: In order to get a good signal from the GPS module, please place the module outdoors when using it.

UART protocol: baud rate (default is 9600bps), data bit (8 bits), start bit (1 bit), stop bit (1 bit), check bit (none).

COM.GPS RXD/TXD can be connected to M5Stack's UART (TX(0/13/17)RX(5/15/16)) by setting the DIP switch, M5Stack Fire GPIO16 /GPIO17 is connected to PSRAM by default. It is recommended to use any one of the remaining two groups of pins.

The right dial switch is invalid for this module, no need to set.

1x COM.GPS Module

1x External antenna(length: 1 m)

GPS-based logistics tracking management

Driverless car positioning

GPS Info (GPS): https://www.u-blox.com/zh/product/neo-m8-series

TinyGPS++ Library: http://arduiniana.org/libraries/tinygpsplus/

Arduin IDE

Click here to download the Arduin example: https://github.com/m5stack/M5-ProductExampleCodes/tree/master/Module/COMX_GPS

Note: In order to get a good signal from the GPS module, please place the module outdoors when using it.

For more information,please refer to u-blox 8 / u-blox M8 Receiver Description - Manual